Free Shipping on Most Orders over $99.99
6 Month no interest, no payments available
through Bill Me Later and PayPal!

Amplifiers

SORT BY

  • LOW - HIGH
  • HIGH - LOW
  • A - Z
  • Z - A
Suhr Bella Reverb Hand-Wired 1x12 Combo - Tolex Front

$2295.00

image

Bella Reverb 1x12 Combo 


SUHR BELLA AMPLIFIERS
Bella is a portable, American voiced, hand-wired, all-tube amplifier, designed to be the ideal grab-n-go amplifier and the ultimate platform for your pedalboard. Bella’s simple and easy to use controls (including Boost and 3-position Bright switch) make it a snap to tailor the amp to your favorite boost, overdrive, fuzz and distortion pedals; while the effects loop is the ideal place for all of your chorus, flange, delay, and reverb pedals.
Bella is powered by a duet of 6L6GC power tubes that deliver either 22 or 44 Watts of Class A/B power and is available in a head or combo format, with or without reverb.


100% HANDWIRED
Each Bella amplifier is meticulously hand wired, assembled, and tested in our Lake Elsinore, CA factory.

SELECTABLE WATTAGE
The Bella can be selected to run at either 44 or 22 watts. Choose 44 watts when you need the boldest tone with the most clean headroom. Choose 22 watts when you want the amp to break up sooner and at lower volumes

SWITCHABLE BOOST & BRIGHT
TWO POSITION BOOST: This 2-position switch varies Bella’s input gain stage via the front panel or the footswitch jack located on the back of the amplifier. Engaging the boost provides +6dB of boost at the first gain stage.

THREE POSITION BRIGHT: The bright switch has three selections available.

  • Bypass
  • In the down position: the Bright switch is out of the circuit.
  • In the middle position: Bella introduces a modest amount of brightness that brings out the guitar’s upper frequencies.

If you desire more organic chime, set Bella’s Bright switch to the up position. This position naturally opens up the top-end, allowing all of your guitar’s higher frequencies to shine through.

TRANSPARENT EFFECTS LOOP
Bella is equipped with a full-featured, all-tube series effects loop which performs equally well with pedals and line-level rack gear via the loop’s independent send and return controls. The effects loop was designed to be extremely clean and transparent, making it the ultimate effects platform.

YOUR PEDALS HAVE NEVER SOUNDED SO GOOD
Bella has been specially designed with your pedals in mind and it’s the ultimate, clean, pedal platform. It responds to virtually any pedal in a tone-full way and even the bright switch is friendly with most overdrives and distortions.

VERSATILITY ON THE FLY
The standard Bella has a single button foot switch available for the selectable boost. The Bella Reverb has a two button foot switch available to remotely switch the boost and reverb circuit.

TUBE DRIVEN SPRING REVERB
Available on select models
The optional reverb circuit was painstakingly designed to offer players the ultimate reverb experience without coloring or altering the sound of Bella or your instrument’s natural tone.


SPECIFICATIONS:
Bella Reverb 1x12 Combo

  • Street Price - $2,295
  • SKU - A-BEL-RC
  • Output - Switchable 44/22 Watts RMS
  • Preamp Tubes - 3x 12AX7
  • Power Tubes - 2x 6L6GC
  • Reverb - Tube driven spring reverb
  • Effects Loop - Tube driven, buffered, with independent send and return levels.
  • Speaker - Celestion V-Type (60 Watts)
  • Front Panel - Input, Boost Switch (2-Position), Bright Switch (3-Position), Volume, Treble, Bass, Presence, Reverb, Standby/Wattage Selector Switch, and On/Off Power Switch
  • Back Panel - Mains Input Inlet, Mains Fuse, H.T. Fuse, Speaker Impedance Selector: (2Ω, 4Ω, & 8Ω), 2-External Speaker Outputs, Effects Loop Return Level, Return and Send Jacks, Send Level, In/Out Switch and Boost - Footswitch Jack.
  • Dimensions - 24” (W) x 9.90” (D) x 19.50” (H)
  • Weight - 51lbs
hidden field
Suhr SL67 Hand-Wired 50 Watt PLEXI Style Head

$1995.00

image

SL67

SUHR SL SERIES AMPLIFIERS
The Suhr SL67 and SL68 amplifiers are no compromise, hand wired, amplifiers built to deliver the complete range of classic British-style tones at any volume. From sparkling cleans to screaming high-gain Variac™* style overdrive tones, the SL Series responds dynamically to every nuance of your playing style and instrument with just a turn of your guitar’s volume control.
Each SL amplifier features hand wired construction, four inputs (Normal and Treble), Low/High power switch, Master Volume control (located on the back panel), and is powered by EL-34 power tubes and three 12AX7 preamp tubes.

SINGLE CHANNEL WITH 4 INPUTS

  • CHANNEL I INPUT TOP: Has a high sensitivity and voiced brighter than Channel II.
  • CHANNEL I INPUT BOTTOM: Has low sensitivity and offers a slightly warmer tone.
  • CHANNEL II INPUT TOP: Has high sensitivity and offers a normal/bassier tonal response.
  • CHANNEL II INPUT BOTTOM: Has low sensitivity and a normal/bassier tonal response.

VARIAC™* POWER MODE
The three position power switch incorporates a low power Variac™* mode which lowers the amount of voltage available to the amp. This classic mod makes the amp feel much more spongy with a smoother attack and has been the foundation for some of the greatest rock tones of all time. To avoid having to re-bias the amp when switching power modes, SL amplifiers have two internal bias adjustments, one for HI power, the other for LOW.

CUSTOM “PLEXI” OUTPUT TRANSFORMER
Output transformers have a major impact on tone. It’s the bridge between the output section of the amplifier and your speaker cabinet. We’ve spent countless hours listening to different transformers until the spec was finalized for our custom “PLEXI” output transformer. This transformer sounds clear, is dynamic, and lends authoritative authenticity to the amplifier.

MASTER VOLUME CONTROL
Suhr SL amplifiers feature a Post Phase Inverter Master Volume control. This type of master volume control is highly effective at transparently controlling the output of the amp. When the control is at 10, it is completely transparent and out of the circuit. Start turning it down, and the amps volume can be reduced all the way to whisper levels.

100% HANDWIRED
Every Suhr SL67 and SL68 amplifier is meticulously hand wired, assembled, and tested in our Lake Elsinore, CA factory.

AVAILABLE CONFIGURATIONS
Suhr SL amplifiers are available in the following two configurations:

SUHR SL67 (50 Watts)

  • 50 Watt EL34 Power Section
  • Portable Small Box Head Configuration

SUHR SL68 (100 Watts)

  • 100 Watt EL34 Power Section
  • Classic Large Box Head Configuration


SPECIFICATIONS
SUHR SL67

  • PRICE - $2,495
  • SKU - A-SL67
  • Output - 50 watts RMS
  • Preamp Tubes - 3x 12AX7
  • Power Tubes - 2x EL34
  • Front Panel - OFF/HI/LOW Power Select Switch, Presence, Bass, Middle, Treble, Volume I, Volume II controls and four Inputs
  • Back Panel - Master Volume, two Speaker outputs, Impedance Selector (4Ω, 8Ω, & 16Ω), HT Fuse, Mains AC Inlet and Mains Fuse
  • H.T. Fuse - F 0.5A/250V (Fast-Blo)
  • Dimensions - 26” (W) x 8.25” (D) x 10.25” (H)
  • Weight - 42lbs

*Suhr 2×12 Deep Extension Cabinet - Black/Gold available separtely.

hidden field
Suhr SL68 Hand-Wired 100 Watt PLEXI Style Head

$2995.00

image

SL68

SUHR SL SERIES AMPLIFIERS
The Suhr SL67 and SL68 amplifiers are no compromise, hand wired, amplifiers built to deliver the complete range of classic British-style tones at any volume. From sparkling cleans to screaming high-gain Variac™* style overdrive tones, the SL Series responds dynamically to every nuance of your playing style and instrument with just a turn of your guitar’s volume control.
Each SL amplifier features hand wired construction, four inputs (Normal and Treble), Low/High power switch, Master Volume control (located on the back panel), and is powered by EL-34 power tubes and three 12AX7 preamp tubes.

SINGLE CHANNEL WITH 4 INPUTS

  • CHANNEL I INPUT TOP: Has a high sensitivity and voiced brighter than Channel II.
  • CHANNEL I INPUT BOTTOM: Has low sensitivity and offers a slightly warmer tone.
  • CHANNEL II INPUT TOP: Has high sensitivity and offers a normal/bassier tonal response.
  • CHANNEL II INPUT BOTTOM: Has low sensitivity and a normal/bassier tonal response.

VARIAC™* POWER MODE
The three position power switch incorporates a low power Variac™* mode which lowers the amount of voltage available to the amp. This classic mod makes the amp feel much more spongy with a smoother attack and has been the foundation for some of the greatest rock tones of all time. To avoid having to re-bias the amp when switching power modes, SL amplifiers have two internal bias adjustments, one for HI power, the other for LOW.

CUSTOM “PLEXI” OUTPUT TRANSFORMER
Output transformers have a major impact on tone. It’s the bridge between the output section of the amplifier and your speaker cabinet. We’ve spent countless hours listening to different transformers until the spec was finalized for our custom “PLEXI” output transformer. This transformer sounds clear, is dynamic, and lends authoritative authenticity to the amplifier.

MASTER VOLUME CONTROL
Suhr SL amplifiers feature a Post Phase Inverter Master Volume control. This type of master volume control is highly effective at transparently controlling the output of the amp. When the control is at 10, it is completely transparent and out of the circuit. Start turning it down, and the amps volume can be reduced all the way to whisper levels.

100% HANDWIRED
Every Suhr SL67 and SL68 amplifier is meticulously hand wired, assembled, and tested in our Lake Elsinore, CA factory.

AVAILABLE CONFIGURATIONS
Suhr SL amplifiers are available in the following two configurations:

SUHR SL67 (50 Watts)

  • 50 Watt EL34 Power Section
  • Portable Small Box Head Configuration

SUHR SL68 (100 Watts)

  • 100 Watt EL34 Power Section
  • Classic Large Box Head Configuration

SPECIFICATIONS
Suhr SL68

  • PRICE - $2,995
  • SKU - A-SL68
  • Output - 100 watts RMS
  • Preamp Tubes - 3x 12AX7
  • Power Tubes - 4x EL34
  • Front Panel - OFF/HI/LOW Power Select Switch, Presence, Bass, Middle, Treble, VolumeI, Volume II controls and four Inputs
  • Back Panel - Master Volume, two Speaker outputs, Impedance Selector (4Ω, 8Ω, & 16Ω), HT Fuse, Mains AC Inlet and Mains Fuse
  • H.T. Fuse - F 0.5A/250V (Fast-Blo)
  • Dimensions - N/A
  • Weight - N/A
hidden field